Rapid-air AIR FEED / RAPID MASTER WITH KEYPAD Uživatelský manuál

1RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.comair feed

10The attempt is made to start the machine by pulling the mushroom start button but no lights illuminate.The attempt is made to cycle the feed but th

11Problem Possible Causes Remedycharacteristics and possible causes of troubles with rapid-

12Problem Possible Causes Remedycharacteristics and possible causes of troubles with rapid-

13Problem Possible Causes Remedycharacteristics and possible causes of troubles with rapid-

14Programming Procedure

15Programming Procedure

16Air Feed Speed Adjustment

17Programming Procedure

18Electrical Assembly

19Operator Keypad

2INSTALLATION AND MECHANICAL SET-UP OF DIE OR PUNCH ... pg. 3AIR FEED PROGRESSION SET-UP AND MAI

20Control Panel Wiring Diagram

21Rapid Master Unit with Air Feed

22Rapid Master Mechanical Setup

23ALL SALES BY THE COMPANY ARE MADE SUBJECT TO THE FOLLOWING TERMS AND CONDITIONS. PLEASE READ.WARRANTY – The Company warrants, for a period of one

3The Rapid Master that you have just re-ceived is fully assembled and ready to be put into production. Due to shipment vibration and handling, the ma

4The feed guide rollers are adjustable by loosening the machine screws and moving the rollers to the desired posi-tion. For best result, the stock sh

5For a general guide for the Rapid Master, the lubricator oil release adjustment should be set to one drop of oil for each 50-80 strokes. (See insert

61. Master power on/off buttonLighted 2 position switch, located on the side of the console. When turned on the switch should illuminate.2. Tonnage

7A. Taut stock inputThis is a normally open contact from a switch or device that monitors the loop of material prior to the air feed. When the mater

8The intent of this section is to familiarize the operator with the program flow and what to expect with every keypress. Each screen on the display wi

9The unit is now in full automatic. Whenever an input for feed is received, the air feed will feed the cycles programmed and increment the counter by